# Every number we did NOT measure lives here, with its evidence. # tag: "derived" = computed from real data by a stated rule; "assumed" = standard/engineering value, sensitivity-tested. # A file in data/measured/ always overrides these (see derive.py). [direction_split] # Share of a two-way peak-hour count going in each direction. # Rule: use MoDOT 2025 directional AADT ratio for that road (derived); peak skew on top is assumed 0 by default. rule = "modot_directional_ratio" peak_skew = 0.0 # +0.05 would push 55/45 toward the heavier direction; sensitivity-test tag = "derived" evidence = "MoDOT 2025 directional AADT (data/raw/modot); peak-hour skew unknown, set to 0 and varied in sensitivity tests" [peak_hour_factor] # Peak-hour volume as a share of daily volume, for roads with only daily (AADT) data (Forsyth, Wydown). rule = "median of County stations on this corridor (PkHrVol / AWT)" tag = "derived" evidence = "County count stations listed in corridor.toml [peak_factor]" [peak_hour_note] text = "County 'peak hour' is the busiest hour of the count day; at a few stations that is AM (8:00). Used as the PM design hour." tag = "assumed" [turn_shares] # Share of each approach turning Left / going Through / turning Right. No turning counts exist (field session will measure). main = { L = 0.10, T = 0.80, R = 0.10 } # Big Bend side_minor = { L = 0.30, T = 0.40, R = 0.30 } # small cross streets (Forsyth, Wydown) side_major = { L = 0.12, T = 0.76, R = 0.12 } # major cross roads (Forest Park Pkwy, Clayton Rd) tag = "assumed" evidence = "Typical arterial/cross-street shares; replaced by field counts when available; sensitivity-tested" [signal] lost_time_per_phase_s = 4.0 # yellow + all-red per phase yellow_s = 3.5 all_red_s = 0.5 tag_lost_time = "derived" evidence_lost_time = "ITE yellow-change formula at 30-35 mph gives ~3.5-4 s, plus all-red; 2 phases -> L = 8 s" sat_flow_per_lane_vph = 1800 tag_sat_flow = "assumed" evidence_sat_flow = "Textbook value (HCM base 1900 pc/h/ln with typical urban adjustments)" lanes_main = 2 # through lanes per direction on Big Bend (MoDOT 2025 + OSM) lanes_side_default = 1 # per direction on cross streets unless MoDOT says otherwise tag_lanes = "measured" evidence_lanes = "MoDOT 2025 segment lanes field + OpenStreetMap lane tags" [model] # Michael + Noah's model parameters (notes/meeting-prep-2026-11-10.txt). Theirs to change. # lost_time_basis: "signal_sequence" = L per light is the total yellow+all-red along the County's real phase sequence # (critical ring, both blocks; ~25 s), consistent with how SUMO runs the plans; "two_phase" = one clearance per block (~12 s). lost_time_basis = "signal_sequence" # capacity_basis: "signal_sequence" = each approach's saturation flow s handed to the model is an EFFECTIVE value # q / Y_block, where Y_block is the critical flow ratio of that block along the real phase sequence (left arrow + opposing # through, worst ring; lefts on a 1-lane bay, through+right on the through lanes). "lanes" = lanes x sat flow per lane. capacity_basis = "signal_sequence" p_platoon = 0.8 g_min_s = 10.0 C_min_s = 60.0 C_max_s = 150.0 x_max = 0.9 tag = "assumed" evidence = "Model defaults from the Nov 10 meeting prep" [speeds] # Posted speed limits (MoDOT 2025): 30 mph north of Forsyth, 35 mph south. north_of_forsyth_mph = 30 south_of_forsyth_mph = 35 tag = "measured" evidence = "MoDOT 2025 speed_limit field" [current_timing] # No public data. Placeholder for the "current timing" baseline until stopwatch/County numbers arrive. C_s = 120.0 main_share = 0.65 # share of (C - L) given to Big Bend offsets = "zero" # unknown tag = "assumed" evidence = "Placeholder only: typical suburban arterial cycle. Replace with field stopwatch or County timing sheets."